Description
The handlebar switch PB-1 is electric motorcycle accessory. It is available for metric handlebars with a diameter of 22.23 mm and for imperial handlebars with a diameter of 1 inch / 25.40 mm. It has a load capacity of 50mA and is therefore suitable to provide a control signal of max. 50mA. The handlebar switch PB-1 is the ideal complement to our electronic load relay SER-100 but can also be used in combination with other electronic relays or button control units.
CAUTION: Do not use the button to switch a load such as an auxiliary light or a horn directly. Not suitable for use on off-road vehicles or when exposed to heavy dirt. Use only on motorcycles, trikes, quads etc. with 12V electrical system. Disregard of these instructions will cause loss of warranty.
Technical Data
| Operating voltage | 3 – 32V DC |
| Load capacity | max. 50mA |
| Principle of operation | single pole normally open, momentary contact, off (on) |
| Operating temperature | -40°C – 85°C |
| Measurements | 15 x 12 mm (D x H) |
| Connection wires | 600 mm / 23,6 inches each |
| Water / dust protection | partially encapsulated, IP67 |
|
Material |
Aluminium, natural or black anodized |
Scope of Supply
- 1 handlebar switch PB-1 with 600 mm leads
- 1 black zip tie 3.6 x 150 mm
- 1 black heat shrink tubing 3.2 x 550 mm
